Suitable for applications that require measurements in the UV-visible range. Jenway™ 6305 UV/Visible Spectrophotometer includes multi-parameter displays, full interfacing capability, and versatile sampling accessories. SPECTROPHOTOMETER 6305

550 portable pH meter supplied in carry case with epoxy combination pH electrode, ATC probe and batteries. A small, lightweight general purpose pH meter offering 2 point pH calibration and automatic buffer recognition. Simultaneously displays both the temperature compensated pH readings and temperature. 550 Portable PH Meter

570 portable pH, mV meter supplied in carry case with epoxy combination pH electrode, ATC probe and batteries. Is a general purpose pH, mV and temperature meter with an integrated rubber seal to ensure that it’s completely waterproof. This model displays either temperature compensated pH readings or electrode potential and temperature. 570 Portable PH meter

The first scanning spectrophotometers in the Jenway range to leverage diode array technology to produce exceptionally fast results. 7205 UV / VIS Spectrophotometer, 10x10cm Cuvette holder, EU connector

Offers accuracy with 1, 2 or 3 point conductivity calibration across the wide measurement range of 0 to 19.99S. Jenway™ 4520 Conductivity Meter ensures optimum accuracy with a dedicated “pure water” mode. Model 4520 Conductivity/temp meter

Parts and accessories that keep your flame photometer operating X3 Ignition electrodes for PFP7

500ML pH 10 buffer solution, blue

DEUTERIUM LAMP FOR 6105

Requires a much more narrow range of wavelengths. Jenway™ Fluorimeter Interference Filter allows a specified wavelength and light to pass through to the sample. Interference Filter Wavelength 690nm

Use this buffer to care for Jenway pH electrodes. Jenway™ Buffer Sachets are tailored to your specific probe. X10 buffer pH4 solution sachets (pack of 10)

Parts and accessories needed to keep your flame photometer operating at its best WATER SEPARATOR WITH REPAIR KIT

500ML Conductivity calibration standard 12.88mS (500ml)

Parts and accessories to expand analysis capabilities Peltier for 73 series spectrophotometers JENWAY

CUT OFF FILTER 610 NM

Jenway™ Interference Filters are fluorometer filters suitable for narrower wavelength requirements. Interference Filter Wavelength 610nm

Better performance on your spectrophotometers Interference Filter Wavelength 280nm

Useful parts for optimization of your fluorimeter 6505 Application card (Re-boot disk)

Compact unit that provides accurate and reliable readings. Model 3520 pH meter supplied as above with USpower supply, 1/Cs, MA: 352101

254NM FILTER FOR FLUORIMETER

Pre-programmed with all the most common methods for protein analysis including Bradford, Lowry, Biuret, BCA and Direct UV methods. Jenway™ Genova Plus Life Science Spectrophotmeter can also be used as a standard spectrophotometer with measurement modes for photometrics, concentration, multi-wavelength, spectrum scanning, quantitation, and kinetics. Spectrophotometer Genova Plus JENWAY

Standard, Three Block, Matrix Head

Storage/carry case

XENON LAMP JENWAY

Food pH electrode with S7 connector for use with Model 430 Food pH electrode with S7 connector (430)

Parts and accessories to expand analysis capabilities or make testing easier. 20ml DNACON Solution, calibration standard

Fuel filter

Use this spectrophotometer QC and testing procedures for a wide variety of services and industries. Jenway™ 6320D Visible Spectrophotometers are high quality, low cost units for spectrophotometric applications in schools and colleges. SPECTROPHOTOMETER 6300

KCl fill solution for DO2 probe (30ml)

Calibration standard 140mmol/l Sodium, 5mmol/l Pot

Creates a virtual dilution of 1:10 or 1:50 when compared to a measurement with a standard 10mm cuvette. Jenway™ TrayCell Fibre Optic Cuvette accommodates 0.7 to 5µl of sample. Tray Cell for ultra-micro sample volumes